Are you using this for a or for production programming ?
The standard, low-cost hardware debug interface from Infineon.
Launch the Memtool_4.9_Setup.exe file with administrative privileges.
Navigate to the official or the Infineon MyICP portal.
: The software opens communication via the Device Access Port (DAP) or Joint Test Action Group (JTAG) interface, checking silicon IDs against its internal database.
: Supports a limited set of batch commands (e.g., connect , open_file , program ) to automate repetitive flashing tasks via .bat files. Supported Microcontroller Families
Except for one byte at offset 0x1F4. Value: 0x01.
, UART, Device Access Port (DAP), and JTAG using tools like the Infineon miniWiggler Infineon Developer Community Technical Details for Version 4.9 Included Software : This version bundles the Infineon Device Access Server (DAS) V7.3.7 OS Compatibility : Specifically supports Microsoft Windows 10 (64-bit) Installation : Requires administrator permissions to run the or the standalone executable. Batch Mode
FLASH Erase 0x8000 0x1000 MEM Fill 0x8000 0x1000 0xFF FLASH ProgramHex "C:\firmware.hex"
Obtain the MemTool 4.9 installation package from the Infineon Software Tools website .
The typical programming workflow consists of:
Ensure the target microcontroller board is powered with the correct voltage.
Before launching Memtool, verify that your hardware connection is correct:
After programming, run the "Compare" check to ensure that the memory contents match the hexadecimal file precisely. 4. Setting Protection
