Autokent Mvci Multi Driver X64 Install Jun 2026

Launch your automotive diagnostic software (e.g., ). Navigate to the top menu and select Setup > VIM Select .

Right-click the AutoKent installer executable and select .

: Switch the cable to a different USB port. Ensure the red or green LED light on the cable housing turns on when connected to the PC. Techstream Crashing on 64-bit Windows

: Windows Driver Signature Enforcement blocked the unsigned virtual communication port driver. autokent mvci multi driver x64 install

Download the package from a trusted automotive forum or resource.

Even with an automated installer, problems can occur. Here are some common issues and their suggested solutions.

Extract the contents of the Autokent MVCI download folder. Launch your automotive diagnostic software (e

Launch your diagnostic software (for example, ). Navigate to the Setup or Configuration menu. Click on VIM Select (Vehicle Interface Module).

To verify: Open the MVCI_Config_Tool.exe . Under “Device Info,” you should see:

Plug your MVCI USB cable into a on your computer. Avoid USB 3.0 (blue) ports, as older clone cables frequently experience packet loss or synchronization errors on newer USB controllers. : Switch the cable to a different USB port

Before installing the Autokent MVCI Multi Driver x64, ensure that your computer meets the following system requirements:

He shut the lid, the laptop's glow dimming. Tomorrow he would upload the README to the forum, paste the steps, and sign off with a single sentence: "Worked for me — here's how." Somewhere in a threaded corner, a reply would light up, another user would read, and the chain of shared fixes would inch onward. For now, the room hummed, the dongle blinked, and an old sedan on the lift awaited its next conversation.

Windows will attempt to recognize the device. Open (press Win + X then select Device Manager) to verify.

Verify that your device (e.g., BUMBLEBEE or Mini-VCI ) is listed here.

| Error Code | Message | Solution | | :--- | :--- | :--- | | | Unsigned driver | You forgot to disable signature enforcement. Reboot into the special startup settings. | | Code 10 | Device cannot start | USB power issue. Use a powered USB hub or change ports. Re-flash firmware. | | Code 28 | Driver not installed | Windows did not find the INF file. Manually select “Have Disk” and point to the .inf in the x64 folder. | | Device vanishes | Disconnects randomly | Bad USB cable. Replace with a shielded, short (1m) USB 2.0 cable. |