There is because CipherLab doesn’t manufacture the USB-serial chip. Use the chipset-specific driver based on the cable’s hardware ID. If the cable came with a CipherLab scanner kit, check the original CD or CipherLab’s legacy support page for a “USB driver pack” — but that pack will still contain one of the three drivers above.
A: Yes, as long as the scanner uses standard RS232 communication with a DB9 connector. However, you must match the pinout (usually a standard DTE-to-DTE configuration with a null modem adapter if needed).
Works with CipherLab 150x, 156x, 166x, 8xxx, and 25xx series. OS Support: Windows (XP to 11), Linux, and Mac OS. cipherlab 308 usb-to-rs232 interface converter driver
Insert the CipherLab 308 converter directly into a native USB port on the motherboard (avoid unpowered USB hubs).
The CipherLab 308 interface converter typically utilizes the Silicon Labs CP210x USB to UART Bridge A: Yes, as long as the scanner uses
If you encounter issues while setting up your CipherLab 308 converter, use these proven diagnostic fixes: "Error Code 10: Device Cannot Start"
Follow this structured installation sequence to prevent device recognition failures or system conflicts. Phase 1: Preparation OS Support: Windows (XP to 11), Linux, and Mac OS
: Once installed, the driver assigns a specific COM port number to the device, which can be viewed in the Windows Device Manager under "Ports (COM & LPT)". Driver Installation Guide