Xc2003 Controller Manual [repack]

The controller feeds at high speed for the fixed window length, then drops to a slower searching speed until the sensor detects the color mark.

: Supports various analog inputs and temperature sensors to monitor machine health. Adjustable Parameters

: Provides detailed technical information about the controller, such as input and output specifications, accuracy, response time, and environmental conditions.

IP65 (dust-tight and protected against water jets). xc2003 controller manual

This article serves as a comprehensive guide to the , covering its key features, operational procedures, and troubleshooting steps based on available technical documentation. 1. Overview of the XC2003 Controller

A fold-out (or multi-page PDF spread) "Quick Reference Card" of terminal assignments, allowing you to trace a physical wire back to its logical address without flipping chapters.

Displays the target cutting or feeding length in millimeters. The controller feeds at high speed for the

: To initiate DPF (Diesel Particulate Filter) regeneration, users navigate through the settings menu: Access General Settings (middle button on the left). Navigate to 1130 Stationary Regeneration to enable it. Set 1140 DPF Regeneration Mode to "Forced".

| Parameter | Value | |-----------|-------| | Power supply | 24V DC (19.2–28.8V) | | Max dissipation | 5W | | Digital input frequency | 10kHz (max) | | Output type | NPN open collector, 0.5A, 24V DC | | Analog resolution | 12‑bit (0‑4095) | | Program memory | 128 KB (approx. 8000 steps) | | Dimensions | 90 x 70 x 55 mm | | Mounting | DIN rail (EN 60715) |

Do not connect EGND to GND directly unless using a single-point ground system. This creates ground loops. IP65 (dust-tight and protected against water jets)

Install the controller inside an IP54-rated electrical enclosure to protect internal circuits from dust, oil mist, and humidity.

Sends frequency signals to the stepping or servo driver to control motor speed and distance.

A: You can adjust the pressure bands by pressing and holding the Enter button and navigating to the pressure menu.

: Designed to replace older models and work across various engine brands. Rugged Hardware

To change the working pressure using PACE technology, follow these steps on the main screen: