Staples 17466 Laminator Manual

The will illuminate immediately, indicating the heating element is active. Step 2: The Warm-Up Period

Do not laminate heat-sensitive papers (like thermal receipts), wet items, or extremely thick cardstock.

Wrinkles are almost always due to the pouch being inserted crookedly. Always use the feed guides to keep the pouch straight. If a jam occurs, do not force the pouch. Turn off the machine, unplug it, and gently pull the pouch back out. A release lever is available on some models to assist with clearing jams.

If the machine was recently used on a hot setting, wait at least 30 minutes for the internal rollers to cool down completely. The green "Ready" light will signal when it is safe to proceed. staples 17466 laminator manual

The Staples 17466 is a reliable, compact thermal laminator designed for home, office, and classroom use. Whether you are preserving important documents, creating classroom visuals, or protecting frequently handled reference sheets, this machine delivers professional results.

: If the machine remains idle for 30 minutes, it enters a power-saving mode where the LED will flash for 5 minutes before turning off completely. Heat Management : If using both hot and cold settings in one session, the Staples instruction guide recommends performing cold lamination first

Ensure it is securely plugged in and the outlet has power. Cleaning the Rollers Always use the feed guides to keep the pouch straight

Once the "Ready" light is on, you can begin the lamination process.

straight into the entry slot. The rollers will grab the pouch and pull it through automatically.

Every project begins with patience. Once you flip the power switch, the orange "X" light flashes, signaling that the internal rollers are heating up. It usually takes to reach the ideal temperature. You'll know it's ready when you hear a beep and the green check mark glows steadily. 2. Choosing Your Path A release lever is available on some models

The standard for heavy-duty protection like ID cards or menus.

Allow the pouch to pass through completely before removing it. Cold Lamination Set to Cold: Switch to the "Cold" position.

: Center your item inside the pouch, ensuring it touches the leading sealed edge

Place the laminator on a flat, stable, and heat-resistant work surface. Ensure there is at least 6 inches of clear space behind the machine so the laminated document can exit freely without bending or jamming. Step 2: Powering On and Selecting Mil Setting

Place the laminator on a flat, heat-resistant, stable surface. Ensure the front and rear exits are unobstructed.