Xmtd-2201 Manual !link!

| Parameter | Value | |-----------|-------| | Power supply | 100–240V AC 50/60Hz or 24V DC | | Input type | K, J, E, T, S, PT100, 0–10V, 4–20mA | | Output type | Relay (3A/250V), SSR drive (12V/30mA), linear | | Accuracy | ±0.5% FS ±1 digit | | Sampling rate | 2–4 Hz | | Control mode | ON/OFF, PID, auto-tuning | | Alarm | 1 or 2 relays (high/low/deviation) | | Working temp | 0–50°C | | Dimensions | 48×48×90 mm (DIN standard) |

To ensure your XMTD-2201 lasts for years:

Configuring the XMTD series requires understanding the specific digital codes used in the "Adjusting Mode" menu: Sets the display to two or three digits.

For models equipped with PID capabilities, an Auto-Tune feature can optimize the controller for your specific system. To activate Auto-Tune: xmtd-2201 manual

Only active if P = 0 . Prevents relay chattering around SV. 2.0 0.1 to 100.0°C Sc

Connect three-wire sensors using low-resistance copper conductors of identical length. Operator Panel Layout and Displays

Relay (3A AC220V) or Solid State Relay (SSR) trigger 2. Wiring Diagram and Installation | Parameter | Value | |-----------|-------| | Power

| Terminal | Function | |----------|----------| | 1, 2 | Power (L, N or +24V, 0V) | | 3, 4, 5 | Thermocouple / RTD input (e.g., 4: +, 5: -) | | 6, 7 | Relay output (normally open) | | 8, 9 | Alarm 1 output | | 10, 11 | SSR drive output | | 12, 13 | 4–20mA output (if present) |

Before powering the device, ensure the terminal connections match your specific model.

Secure the instrument in your control panel using the included mounting brackets. Prevents relay chattering around SV

. This is critical for protecting equipment from overheating or ensuring a process stays within a specific thermal window. www.clin-ele.com 5. PID & Control Flexibility Depending on the specific variant, the device offers: PID Control:

This is the most common task. You don't need to enter a deep menu for this: button once briefly. The SV display should start flashing. Down (▼) arrows to reach your desired temperature.