Weierwei Vev-3288s Programming Software -

Select high or low power to conserve battery.

| Error Message | Solution | |---------------|----------| | “Radio not responding” | Reinstall Prolific driver v3.3.2.105. Disable USB selective suspend. | | “Model mismatch” | Confirm you have Vev-3288s, not Vev-3288 (different firmware). Try v2.03 software. | | “Checksum error” | Read radio twice. Write back original codeplug before editing. | | “Out of range” | Frequency is outside radio’s band split. Check sticker under battery: UHF1 (400-430) or UHF2 (450-470). |

Admin (or RadioTech ) Date: [Current Date] Weierwei Vev-3288s Programming Software

To use the software, you need the following hardware and setup:

Launch the programming software. Before reading or writing data, you must align the software with your hardware. Click on or Communication in the top menu bar. Select Port . Select high or low power to conserve battery

Quickly assign continuous tone-coded squelch systems (CTCSS) or digital-coded squelch (DCS) to eliminate unwanted interference on shared frequencies.

Future research directions for the Weierwei Vev-3288s programming software may include: | | “Model mismatch” | Confirm you have

: Many inexpensive cables use unauthorized chips that modern Windows drivers may block. Using an older driver version often resolves "Code 10" errors. Cable Connection

Note: When using CHIRP, select "Weierwei" as the vendor and "VEV-3288S" as the model. Conclusion