If the keypad becomes unresponsive, you may need to perform a system reset, which usually requires taking off the battery cover and holding a reset button, followed by re-inputting the master code.
To switch between behavior modes, use the indoor command panel:
Install the latch (deadbolt) into the edge of the door, ensuring the "UP" marking faces upward. Secure it with its screws. Then, install the strike plate on the door frame, ensuring the deadbolt can extend fully into it without obstruction.
Use a pin or paperclip to press and hold the reset button for 5 to 10 seconds until you hear a voice prompt or a series of beeps. zeus z3 digital lock manual work
, has become a popular choice for modern, secure smart home access in Singapore. These locks combine biometric technology, PIN code access, and mobile app connectivity to offer high-level security for both home doors and gates. Operating your Zeus Z3 digital lock Go to product viewer dialog for this item.
: Features a 360-degree biometric sensor designed for quick access from any angle.
OneTouch 360° Fingerprint, RFID (Mifare / IC), PIN Code, Backup Key 4 x AA Alkaline 1.5V Batteries (DC 6V) Emergency Power 9V Rectangular Alkaline Battery (External Contacts) Default Master PIN 123456 PIN Code Capacity Up to 10 unique user codes Fingerprint Capacity Up to 100 biometric profiles Initial Setup and Master Configuration If the keypad becomes unresponsive, you may need
When the lock beeps repeatedly after unlocking, or if the keypad response seems sluggish, it's time to change the batteries.
For manual configuration without an app, use the following keypad commands:
Swipe your palm across the keypad to wake the LEDs. Then, install the strike plate on the door
: Wake the keypad and press * then # . You will be prompted to verify the administrator (using the default or existing admin PIN/fingerprint).
From the inside of the door, feed the cable from the exterior handle through the designated slot on the interior mounting plate. Connect the cable to the corresponding port on the interior assembly. Then, attach the interior handle over the spindle, aligning it carefully. Secure the entire assembly using the provided screws.