Taking cubes as basic “point” components, beams as basic “line” components and slabs as “plane” components, this series is integrated with the geometry principle of point, line and plane.C series was made to offer the possibility to set up various models with minimum pieces for maximal use. Students can come to a deeper understanding of the theoretical background by setting up realistic, individual models through practical experience, during which their hands-on and creativity ability also can be motivated.
All electronic and mechanical components are modular design, the main components are integrated into the cube, which can realize three dimensional combination, do not need to use any screws or soft firmware can easily complete system set up.
With various structure parts, connectors, transmission parts, and actuators, the models can be more professionals, which leave more room for students to create.
| Parameter ID | Name | Typical Values | Description | | :--- | :--- | :--- | :--- | | 1 | APN | internet, telstra.datapack | Access Point Name of local carrier | | 2 | Server IP | 52.14.120.89 | Destination for GPRS data stream | | 3 | Server Port | 7008, 8010 | TCP/UDP listening port | | 4 | Heartbeat Interval | 60, 300, 600 (seconds) | How often to send "still alive" signal | | 5 | Movement Start Upload | 10 (meters), 0.1 (minutes) | Distance or time before waking | | 6 | Sleep Mode | 0=Off, 1=Light, 2=Deep | Power saving strategy | | 7 | Geofence 1 | Lat/Lng + Radius | Fence center and radius in meters | | 8 | Time Zone | -5, 0, +8 | Offset from UTC | | 9 | Ignition Detection | 0=Disable, 1=Digital, 2=ACC | How to detect engine ON/OFF |
This defines the balance between real-time visibility and battery life/data usage.
The gateway name provided by your cellular network carrier (e.g., tmobile.com ). Without the correct APN, the device cannot access cellular data. gps tracker parameter editor
Most "GPS Tracker Parameter Editors" are actually software interfaces (or SMS command generators) that modify the of the device.
Modify only the parameters required for your current deployment. If you only need to change the server IP, do not touch the accelerometer calibration or network bands. Step 4: Write and Save | Parameter ID | Name | Typical Values
Install the necessary USB drivers for your tracker. Open the parameter editor software, select the correct COM port, and click or Read Configuration . This pulls the current factory settings from the device RAM. Step 2: Set the Network Credentials
The exact destination address of your tracking software platform. Most "GPS Tracker Parameter Editors" are actually software
The Ultimate Guide to GPS Tracker Parameter Editors: Configuring Your Telematics Devices for Peak Performance
Configure the specific 4G/5G APN (Access Point Name) details so your hardware connects flawlessly with your chosen telematics and GPS tracking server.
Insert the SIM card into the tracker (if required by the hardware) and power the device on. Connect the tracker to your PC via the USB cable. Open the parameter editor and select the correct COM port. Click or Read Parameters to pull the current factory settings from the device. Step 3: Modify the Settings
With abundant interfaces, the output and input ends can be tested on the controller directly.
Dedicated lithium battery 8.4V 1500MAH; maximum discharge current: 6A; built-in protection circuit.
4 motor ports, which can control motors’ speed, rotation orientation; maximum current that single port supports: 2A
Download via cable; Storage space: 3.96M
C1-T
C1-X
C1-P
C1-S
C202
C203