Hw 130 Motor Control Shield For Arduino Datasheet !!link!! Free Jun 2026
Many developers have shared their own code, wiring diagrams, and pinout information for the HW‑130 on GitHub. For instance:
🔓 No signup. No email. The pinout, power table, and code below are your free datasheet.
void setup() stepper.setSpeed(30); // 30 rpm
Search terms:
The HW-130 is designed as a direct "plug-and-play" stackable shield for the . It eliminates messy breadboard wiring by condensing motor drive mechanics into a single robust PCB. Using L293D 4 DC Motors Shield for Arduino UNO and Mega
Used for PWM (Pulse Width Modulation) speed control of the DC/Stepper motors. Digital 9: Reserved for Servo 2. Digital 10: Reserved for Servo 1. Available Pins for External Sensors
Always remove this jumper if your motor voltage exceeds 9V. 5. Arduino Pin Usage and Resource Conflicts hw 130 motor control shield for arduino datasheet free
The HW-130 is an expansion board designed to be stacked directly onto an Arduino Uno, Mega, or similar compatible boards. It simplifies motor control by providing four H-bridges, allowing you to drive various types of motors without building complex external circuits.
The shield also includes an and a selectable power jumper (“PWR”) that lets you decide whether to share the motor supply with the Arduino logic.
Operational from 4.5V DC up to 25V DC (or up to 36V if using upgraded L293D components). Pin Mapping and Interface Layout Many developers have shared their own code, wiring
// --- Motor A Reverse --- digitalWrite(M1_DIR, LOW); // Set Direction Reverse
The shield acts as an interface between the low-power logic of an Arduino and the higher-power requirements of motors. : Utilizes two motor driver chips and one shift register. Motor Capacity : Can drive up to 4 bi-directional DC motors 2 stepper motors (unipolar or bipolar). Servo Support : Features 2 dedicated connections
void setup() pinMode(enA, OUTPUT); pinMode(in1, OUTPUT); pinMode(in2, OUTPUT); The pinout, power table, and code below are
The HW-130 is electrically identical to the – just in shield form. That means any code for the classic L298N module works instantly.
Leave the male jumper cap bridging the two pins.